nRF24LE1 32-pin Breakout Board with RP-SMA Connector

$27.49

Description:
Here we have a breakout of Nordic's nRF24LE1-32 microcontroller module. This chip is similar to the 24LU1 in that it has an on-chip 8051 microcontroller as well as a built-in nRF24L01+ radio! The breakout has all necessary components on-board to get you up and running quickly. The chip comes pre-programmed with a serial bootloader that only requires TX, RX, /RESET, and GND to work!

Features:
  • MCU: Enhanced 8-bit 8051-compatible microcontroller with 16 kB program flash memory, 1 kbytes SRAM, 1 kbyte NVRAM, nRF24L01+-compatible RF transceiver, 3 16-bit timers/counters, encryption/decryption co-processor, 11-input 10-bit ADC, 15 GPIO, 32-bit multiplication-division unit, SPI, UART, 2-wire, PWM
  • On-chip bootloader is compatible with SDCC C compiler
  • On-board 300 mA 3.3V regulator
  • Power LED
  • RESET button
  • On-board RP-SMA connector (requires external antenna)
  • Up to 2Mbps on-air data rate
  • Air-compatible with nRF24LU1, nRF24L01, nRF2401A, nRF2402, nRF24E1, and nRF24E2


  • Documentation/Software:
  • SDK for use with SDCC (currently incomplete)
  • nRF24LE1 Datasheet
  • Schematic
  • Pin Assignment
  • MAX3232 Circuit for Programming
  • PC-side Bootloader written in C# (requires external MAX3232 circuit shown above to work properly!)
  • On-chip Bootloader Source Code (assembles with AS31)
  • Example RF test program

  • Add to Cart:

    • Shipping Weight: 0.1lbs
    • 2 Units in Stock

    Qty Discounts Off Price
    1-9
    $27.49
    10-99
    $24.74
    100+
    $21.99


    This product was added to our catalog on Saturday 14 November, 2009.

    Your IP Address is: 54.198.1.167
    Copyright © 2017 DIYembedded. Powered by Zen Cart